Quote:
Originally Posted by saxo3
Simple, I think these values are not correct for a 32xx movement, IMO.
DU 328° is certainly wrong, 300°-310° max for a 31xx.
6U 271° is more for a horizontal than a vertical position of a 32xx caliber.
Repeat with the 'standard' procedure that was described many times in this thread.
After full winding wait 15 min with the watch at rest in DU position on the timegrapher, then measure for 2 min.
When you change the to the next watch position wait 1-2 min for stabilisation.
All mentioned times depend a bit on whom you ask  |
Repeated the tests with 15 minute wait with watch at rest, 3 minutes between tests and 2 minutes for each test. Obviously I also set the lift angle to 53’ and rate accuracy to 99.9s/d.
All measurements were within the expected range. Putting the timeographer away now and will just enjoy my watch!
Thanks for the help
