![]() |
ROLEXROLEXROLEXROLEXROLEXROLEX
ROLEXROLEXROLEXROLEXROLEXROLEX
![]() |
#1 |
"TRF" Member
Join Date: Dec 2015
Location: california
Watch: 18038
Posts: 8
|
Need some help installing the retaining ring on my Submariner!
Last night I wanted to change the bezel on my 1994 Submariner 14060. I tried to pry it off with a thin knife but ended up removing the entire retaining ring and crystal. I was able to force it back closed with my hands. But this morning I noticed a speck of dust on the inside of the crystal that wasn't there before, and it would drive me mad if I didn't get it out. So I took off the retaining ring again and cleaned the crystal. But now I can't seem to get it back onto the watch, and I've been trying for hours. Do you know of a method for putting it back on without using specific watchmakers' tools? I've heard of using a PVC pipe that's just the right size can work. Any other ideas?
Thanks for helping me undo my stupid mistake! |
![]() |
![]() |
![]() |
#2 |
2024 Pledge Member
Join Date: Jan 2012
Real Name: Richard
Location: Colorado
Posts: 2,858
|
If you have a Harbor Freight store nearby, they sell a very cheap crystal press (like <$15) that will actually work for your situation. Also, you will need to source a fresh crystal gasket because it's not secure to reuse the old one. Personally, I would take it to a reputable watchmaker who probably has the new gasket in stock, has the proper crystal press tool, and can pressure test it for you afterward to ensure waterproof.
|
![]() |
![]() |
![]() |
#3 | |
"TRF" Member
Join Date: Dec 2015
Location: california
Watch: 18038
Posts: 8
|
Quote:
I do actually have one not too far. Is this the press you're talking about? https://www.harborfreight.com/watch-...ies-91621.html I didn't know they sold watchmaker tools! I'll probably take it to my watchmaker soon to get a full service and all gaskets changed because it's due for that anyway, but I just wanted to get it wearable (even if not submergible) in the meantime. |
|
![]() |
![]() |
![]() |
#4 |
"TRF" Member
Join Date: Apr 2024
Location: Colorado
Posts: 5
|
Seated Crystal Retaining Ring
Frustratingly dealing with the exact same issue as the OP on my GMT 16710. I have replaced the rubber gasket that sits under the crystal retaining ring and properly pressed the retaining ring back into place.
Wondering if anyone can confirm if the retaining ring should sit flush against the case, or should the rubber gasket be sitting between the case and the retaining ring? Since there is a channel inside the lip of the retaining ring for the gasket to sit, it seems like it is impossible for the rubber gasket to end up between the retaining ring and the case when pressed. So currently my crystal retaining ring is sitting completely flush against the case with no sign of the rubber gasket at all when fully pressed. Just wanted to see if anyone can confirm this is the correct installation. Thanks in advance!! |
![]() |
![]() |
![]() |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
*Banners
Of The Month*
This space is provided to horological resources.