ROLEXROLEXROLEXROLEXROLEXROLEXROLEXROLEXROLEXROLEXROLEXROLEX

jayv95 · 5 May 2016, 05:17 AM

I have a 1986 16013. I sent it in to have the dial swapped out. After a long two week wait (I had to send the watch to California to have the dial swapped under warranty) I go to set the time. First thing I notice wrong? I pull the crown out to the last setting and the seconds hand does not stop moving.... The seconds hand used to ALWAYS stop.This allowed me to accurately set the time to the second. Not only that, but if when i put a little tension on the crown pin, the seconds hand started going in the OPPOSITE DIRECTION!? what the hell is going on!? I wanted the dial swapped, not a time machine!

Anyways im looking to see if you guys have a clue why something like this would happen, and what could the watchmaker have messed up during the dial swap. Thanks in advance everyone

mannyv11 · 5 May 2016, 05:24 AM

did you send the watch to RSC for the dial swap or did you have an independent do it?

Jocke · 5 May 2016, 06:01 AM

Was it this dial you change to?

It sounds like the small plate that stops the movement in hacking mode is broken or the winding axle is in wrong position.

5 May 2016, 05:17 AM	#1
jayv95 "TRF" Member Join Date: Aug 2015 Real Name: Jeremy Location: NYC Watch: DateJust Posts: 46	Seconds hand spinning backwards??? I have a 1986 16013. I sent it in to have the dial swapped out. After a long two week wait (I had to send the watch to California to have the dial swapped under warranty) I go to set the time. First thing I notice wrong? I pull the crown out to the last setting and the seconds hand does not stop moving.... The seconds hand used to ALWAYS stop.This allowed me to accurately set the time to the second. Not only that, but if when i put a little tension on the crown pin, the seconds hand started going in the OPPOSITE DIRECTION!? what the hell is going on!? I wanted the dial swapped, not a time machine! Anyways im looking to see if you guys have a clue why something like this would happen, and what could the watchmaker have messed up during the dial swap. Thanks in advance everyone

5 May 2016, 06:01 AM	#3
Jocke 2024 SubLV41 Pledge Member Join Date: Apr 2006 Real Name: Jocke Location: Sweden Watch: A dozen of Rolex's Posts: 22,541	Was it this dial you change to? It sounds like the small plate that stops the movement in hacking mode is broken or the winding axle is in wrong position. __________________ This message is written in perfect swenglish. What is best a custom Rolex or a Rolex that is stuck in custom? Buy a professional camera and you´re a professional photographer, buy a flute and you own a flute.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

5 May 2016, 05:24 AM	#2
mannyv11 "TRF" Member Join Date: Jun 2011 Real Name: Manny Location: MA Watch: DD,Sub,GMT,Daytona Posts: 4,507	did you send the watch to RSC for the dial swap or did you have an independent do it?

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)