ROLEXROLEXROLEXROLEXROLEXROLEXROLEXROLEXROLEXROLEXROLEXROLEX
8 February 2019, 05:40 AM | #1 |
"TRF" Member
Join Date: Sep 2014
Real Name: Pete
Location: Toronto, Canada
Watch: 1016.
Posts: 694
|
1560 performance
Ladies and Gents,
Looked out my 1016 today (even with that Sub minute hand it's a favourite) and did the usual time-set and couple of winds before screwing the crown back down and going about my morning. In the first hour, watch gained 4-5 minutes. Uh-oh, magnetized? Reset. Second hour, gained 2-3 minutes. Reset. Last few hours...no discernible gain or loss, seems to be bang on. I remember last time I put this watch on, same thing. At first I thought it was magnetized...but then it calmed down to its regular excellent timekeeping after about three hours. I don't have a timegrapher...I'm sure one of you knows the answer to this conundrum though, so here I am asking - what's up with that? |
8 February 2019, 07:10 AM | #2 |
2024 Pledge Member
Join Date: Oct 2018
Location: Colorado, USA
Posts: 6,260
|
Have you ever tried giving it a thorough manual wind (20-30 turns) instead of just a couple of turns.
__________________
@oldwatchdan on IG |
8 February 2019, 10:58 AM | #3 |
"TRF" Member
Join Date: Sep 2014
Real Name: Pete
Location: Toronto, Canada
Watch: 1016.
Posts: 694
|
That was my thought too. When I last had it serviced I didn't have the mainspring replaced, and it may be that at low states of wind it runs a bit hot...I'll try that next time, I bet you're right and it'll keep good time from the get-go if on full wind. For now of course it's fully wound from being on the wrist all day so I'll just enjoy it until I get a hankering to wear one of his brothers instead.
|
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
*Banners
Of The Month*
This space is provided to horological resources.