Jubilee bracelet link screw issue

[Oli.986]

Hello to all!

I'm a new member and was looking to get some information about a problem I've encountered. I've recently had 4 link screws replaced on my jubilee bracelet at an AD. Its a 2019 Date just (126234) and I've noticed the screws come up short on the thread side ruining the flush polished look of the bracelet. I've been told by the watchmaker these are the correct screws supplied by rolex and they will sit slightly lower, is this a common issue and is there anything I can do to achieve the factory finish look again? I hope the attached photo is clear enough it had to be resized