Question about my new 14060m

[eah990]

I just recieved my 14060m in the mail and cant figure out the divers extension. Is this how it is suppose to look, when I want to put the watch on? Or do I need to snap the seccond flap some how?


Thanks guys

[Grumpy Badger]

Yip, that's fine. If you want to use the extension just give it a gentle tug and the end of the extension on the left of your pick will pop open.

[Genevapics]

I had the same problem when I first bought my 14060m. Looking at your picture:

Grasp the bracelet link (with extension holes) between the thumb and index finger of your right hand. Grasp it right where the divers extension link meets the bracelet link.

Now, with your left hand, place all four fingers between the bracelet, so that the head of the watch rests against the ring and index finger of your left hand.

Slide your left hand up towards the bracelet link (with extension holes) so that your left thumb rests behind the divers extension link and fits inside the bracelet link.

Take your left index finger and pinch the front of the divers extension link.

Now, holding the bracelet link firmly in your right hand, give a push with your left thumb and a pull with your left index finger and the divers extension link should pop out. (NOTE: In your picture, the divers extension link is going to pivot around that column in the bracelet link (with extension holes) located in the third hole from the left.)

[mike]

That's the 93150.